Drummond Shooting Rifle Clearing Trap

When it comes to firearms, safety is the foremost priority.  This clearing trap aids in confirming your guns are clear of all rounds and ready to store or return to a given premises.  The armour-steel chamber filled with rubber mulch allows you to safely dry fire with the confidence that any unexpected rounds will be contained.  This full-size model is designed for rounds from .22 and 9mm up to .223 and .308.  Reinforce the safety procedures of your local range, department or base easily with the addition of this rifle clearing trap.

• AR500 armour steel design
• for rounds up to .223 and .308
• durable polyurethane coating
• rubber mulch filling
• for Mil/LE and shooting ranges
• manufactured in Canada

Description

Construction

This rifle clearing trap is built from steel and coated with a durable polyurethane coating.  The chamber consists of a steel tube which surrounds an inner armour-steel chamber to prevent bullets from escaping.  The chamber is then filled with rubber mulch to absorb bullets and contain potential spalling.

Instructions? That seems appropriate.

With the safety engaged and finger off the trigger, insert the muzzle of your firearm 2-3″ past the rubber blowback gasket, ensuring muzzle is not pressed against rubber mulch inside.  Verify the barrel is parallel to (inline with) the clearing trap’s chamber.  Disengage the safety and fire.  This is an added safety step, so ideally no rounds will be fired. In the event that rounds were still in the firearm, they will be fired and contained safely in the clearing trap.

Maintenance

The rubber should be replaced after every 50 rounds discharged to ensure maximum safety.  To replace the rubber remove the top flange and gasket, tip the clearing trap in the direction of the opening and rest opening on the ground. Remove the rubber and spent bullets.  Tip the trap back upright and refill the chamber with our rubber replacement pack.  Reassemble the gasket, top flange, and bolt until tight.  Your rifle clearing trap is once again ready for service.

The all-weather polyurethane coating protects from rust and resists damage. Regardless of this protection, do not leave the clearing trap in an area where it can fill with water (direct exposure to rain, roof runoff etc.).